Also, if logged in as any user except “Run” (see "User login and editing mode", page 45),
it is possible to change the password for the logged in user.
For security reasons it is strongly recommended to change the password from the initial
default value.
If you have changed and forgotten the password please contact SICK service for sup‐
port.
7.4
Configuration via REST API
SIG200 offers a REST API with a JSON data format to access data of the connected
devices. In this operating manual, an overview about the available device functions and
a basic overview about the access mechanisms are described.
7.4.1 General Interface description
The REST API is a client – server interface and enables the client to request data from
the server through a defined set of resources. The REST API is stateless which means
that no information about the state of connection and no information about the server
or client are required.
The operation is based on HTTP methods. The common HTTP methods are GET, POST,
PUT, and DELETE. However, for SIG200 only the GET and POST request methods are
relevant in which the request and response data is represented in JSON format. JSON,
7 SIG200 CONFIGURATION
54
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
