5 Mounting
The SIG200 is mounted with two screws, maximum M6, and two flat washers.
Note the maximum permissible tightening torque of 0.8 Nm.
Figure 2: Mounting
Scope of delivery:
•
SIG200
•
5 blind plugs (on Port CONFIG, S2, S3, S4, P1)
•
Quickstart instruction
•
20 labels for the label pocket
To ensure an adequate ground connection to the housing make sure the coating on the
housing is removed around the mounting screws.
NOTE
There can be several SIG200 mounted side by side without observing a minimum dis‐
tance between each IO-Link Master.
NOTE
On port P1, S1 and Power there is no protection cap.
NOTE
There are no screws inlcuded in the scope of delivery.
MOUNTING 5
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
9
Subject to change without notice
To Next Page
Loading...
