•
Microsoft Internet Explorer (version 11 or higher)
•
Google Chrome (version 50 or higher)
•
Firefox (version 30 or higher)
•
Safari (version 9 or higher)
To access SIG200 integrated webserver start the browser on your device and enter the
SIG200 IP address.
NOTE
The simultaneous usage of the webserver, PROFINET communication, and user configu‐
ration will result in an increased response time.
NOTE
SIG200 only supports HTTP, the HTTPS protocol is not supported.
The layout and functionality of the integrated webserver as accessed by a browser cor‐
responds to the operation via SOPAS ET (using USB or Ethernet connection), see "Oper‐
ation via SOPAS ET (USB/Ethernet)", page 40.
7.3 Operation via SOPAS ET (USB/Ethernet)
The SOPAS Engineering Tool allows configuring the SIG200 with a personal computer
running Microsoft Windows operating system.
SIG200 configuration with SOPAS ET allows not only to configure the four ports of the
IO-Link Master but also to configure the connected IO-Link devices via an embedded
IODD interpreter.
Additionally, via the Logic Editor (which is a graphical configuration environment) logic
functions across multiple devices which are connected to SIG200 can be created.
The physical connection between SOPAS ET (PC) and the SIG200 can be done either
via USB or Ethernet.
7.3.1 SOPAS ET overview and standard functions on each page
SIG200 pages have the following common layout:
7 SIG200 CONFIGURATION
40
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
