Please be aware that inputs always need to be occupied from top to down (e. g. in
case of two inputs use A+B and not A+D).
The inputs have a red halo when making connections to indicate that the connec‐
tion is still required in this space. The two inputs C and D will only be active in the
logic truth table if a connection is made.
NOTE
Green input arrows and green text: a connection is possible
If a connection is not possible, the text will have red color and it is not possible to
drag a connection to the input.
NOTE
Some inputs and logic gates have a small gear indicating that some additional set‐
tings are possible. Clicking on the gear will open the additional settings dialogue
box and allow for additional configuration (e. g. delay time).
3. Clomplete the setup by using the Transfer and Execute Flow button: the new logic
configuration is transfered to the connected SIG200.
NOTE
An error will appear if there are any improper or missing connections. The notifica‐
tion area will indicate a successful transfer.
7.3.6 Settings
The following settings are possible:
Setting Possible values
Language english / german
Figure 21: Settings
On the settings page, the language of the user interface can be selected (German or
English).
SIG200 CONFIGURATION
7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
53
Subject to change without notice
To Next Page
Loading...
