RUN Click the RUN button to change username access level from "RUN" (read
only) to Maintenance. The Password is “main”. Device settings found on the
Configuration, Logic Editor, and Settings device pages are only possible
when the maintenance mode is active.
NOTE
The device settings on other pages are gray and cannot be changed until
the Maintenance mode is active.
Please ensure that you have clicked on the Edit button on the top right cor‐
ner as well if you would like to do any configurations.
7.3.1.1 User login and editing mode
Changing any SIG200 settings requires logging in as “Maintenance” user (read & write
access). Per default you are logged in as “Run” user (read only) that can only display
data and configuration. To change users click on the user symbol on the bottom left
corner of the page. In the dialog select the required Username. When choosing any user
but “Run” you will also have to enter the appropriate password.
By checking “keep me logged in” it is possible to keep the last user stored even when
closing the configuration tool (SOPAS ET or web browser).
NOTE
Keeping user stored on a web browser might depend on cookie settings.
The following table shows the available users and their initial password:
Table 11: User / Passwords
User Initial password Role
Run (none) Read configuration
Maintenance main Read and write configuration
Please see "Settings", page 53 for details on changing passwords.
7.3.2 Status page
The Status page is the start page of SIG200 and gives an overview of the current mod‐
ule status and device function.
Figure 13: Status page
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
45
Subject to change without notice
To Next Page
Loading...
