Editing Mode
Figure 22: Editing Mode
1. To start your configuration change the operating mode from Run to Maintenance
because the Run mode is a read only mode.
2. Click on Run on the bottom left side and select Maintenance in the drop-down menu.
3. The login password for the maintenance mode is: main
4. Click on Login to select the Maintenance Mode.
Figure 23: Editing Mode
5.
To start with a new configuration, click on EDIT in the upper right corner.
DEVICE FUNCTIONS
8
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
77
Subject to change without notice
To Next Page
Loading...
