SICK WI130 - Time Configuration; Configuring Sensitivity Correction; Detailed Settings (Expert Mode)

Table 6: Time configuration
TOP
t I E r o f f
Select from various time delay options
select and adjust . OFF reverts to initial display.
o F F
No time delay activated
o F d y
OFF-Delay
o n d y
ON-Delay
S H o t
One-Shot
Time period of 1-9000 (1 ms–9 s) can be selected
is for time period change, is for digital change and is
for configuration. The display then reverts to the Time delay
top menu.
o F d y 0 0 0 1
NOTE
Time delay can be set individually for 1x Out and 2x Out.
NOTE
It is not possible to use ON-Delay and OFF-Delay at the same
time in the same channel.
↓
4. Configuring the sensitivity correction
Table 7: Configuring the sensitivity correction
TOP
t u r n o n
Scales the sensitivity range.
Configuration by status is shown in the bar graph. The display
then reverts to the Sensitivity correction top menu.
o n
Switch on the sensitivity
correction.
o F F
Switch off the sensitivity
correction.
↓
5. Detailed settings (expert mode)
Table 8: Configuring the sensitivity correction
TOP
E P r t
Changes to detailed configuration.
table 10
↓
6. Initialization
OPERATING INSTRUCTIONS
8020148.1HRJ/2023-02-08 | SICK O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
51
Subject to change without notice
en