SICK WI130 - Configuration; Configuring Maximum Sensitivity; Single Value Teach-in

3
Control output 1 CH
7
External input
6 Configuration
6.1 Configuration
The available teach-in depends on table 12. See below:
S t n
(Standard detection)
All teach-in are valid.
h d
/
h d
(Contour detection)
No teach-in
d I F F
(Differential detection)
Single Value Teach-in only
6.2 Configuring the maximum sensitivity
Pin on SET
SET RUN
Select Single Value Teach-in.
1 P t
Through-beam / photoelectric retro-reflec‐
tive sensor (WSE/WL): Adjust with object
present.
Press the teach-in button.
1 P t
1 P t g o o d
Proximity sensor (WT): Adjust with no object
present.
Pin on RUN
SET RUN
The threshold flashes and the display
reverts to the initial setting.
6.3 Single Value Teach-in
Pin on SET.
SET RUN
OPERATING INSTRUCTIONS
8020148.1HRJ/2023-02-08 | SICK O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
43
Subject to change without notice
en