SICK WI130 - Return to Operating Mode; Channel Change; Error Output During Teach-in

Return to operating mode with one button
Press and hold down the button for two seconds or longer to return to the normal
setting (operating mode) without using Exit.
NOTE
Invalid while configuring the time type, counter or range.
Channel change
Press the button in operating mode to change the channel. The channel LED
changes at the same time:
1000 1200
1
2
←→
2000 2200
1
2
NOTE
WI130T-P/N340 devices cannot be changed because they only have one output (1x
Out).
Error output during the teach-in
An error message is output if an incorrect entry is made during adjustment. See the
following table for repeating the adjustment.
Table 26: Error output during the teach-in
LED/fault pattern Cause
Err1
Indicates the light intensity is too low.
Err2
Indicates an undetected moving object.
Err3
Indicates a calculation error.
not cPLt
Indicates an interruption of the teach-in.
8 Disassembly and disposal
The sensor must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electric and electronic devices
•
According to international directives, batteries, accumulators and electrical or
electronic devices must not be disposed of in general waste.
•
The owner is obliged by law to return this devices at the end of their life to the
respective public collection points.
•
WEEE: This symbol on the product, its package or in this document,
indicates that a product is subject to these regulations.
OPERATING INSTRUCTIONS
8020148.1HRJ/2023-02-08 | SICK O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
59
Subject to change without notice
en