EOM - WFG
1.4
SICUREZZA COMPAGNIE RIUNITE
General regulations
1.1.c - Reference standards
Hardhat:
EN 397: 2001
EN 443: 1997 Points 5.6 - 5.7 - 5.8.1 - 5.8.3
EN 12492: 2003
1.1.d - Spare parts and accessories
IMPORTANT
Only original spare parts and accessories authorised and certied by the manufacturer
must be used and tted
Using non-original spare parts and unauthorised accessories will invalidate
the warranty conditions and relieve SICOR S.p.A. of all responsibility.
WARNING
- Never apply decals and/or identication labels less than 25 mm from the edges of the
cap; do not use paints, petrol or solvents to clean the hardhat.
Inobservance of these rules may reduce the levels of protection and/or the dielectric
properties.
- Do not modify or remove any of the constituent components of the hardhat.
1.1.e - Storage
IMPORTANT
• The hardhat must be stored in a clean, dry, dark place away from sources of heat and
at a temperature between +10°C (50°F) and +40°C (104°F).
• The hardhat and its accessories must be stored in the bag provided.
• Never leave the hardhat in a vehicle if not in its bag to prevent needless exposure to
the sun (UV rays).
To Next Page
Loading...
Need help?
General