Installation & User Manual, Radio Remote rev 1_0_4 Page 7
How to use a bow/stern thruster
1. Turn the main power switch for the bow/stern thruster on. Turn on main switch so the receiver
has power.
2. Turn on the transmitter by pushing the transmitter’s two “ON” buttons. The remote system is
now activated and then turns o automatically appr. 4 min. after the last usage.
3. Please take some time to exercise thruster usage in open water to avoid damages to your boat.
4. Turn the bow/stern in the desired directiony by pushing the red button for port movement or the
green button for starboard movement.
How to use a bow & stern thruster combined
The combination of a bow and stern thruster oers total manouverability to the boat and the
opportunity to move the bow and the stern separately of each other. The remote middle buttons
gives you the opportunity to operate both thrusters in the same direction with one keypress,
making sidewards movement easier.
Remote Control Deactivation
Push the transmitter’s “OFF” button for 2 seconds (the remote control deactivates automati-
cally after approx. 4 minutes after the last usage).
• If in doubt, try in open water rst!
Remote control “ON” Turn boat to Port
Bow + Stern thruster
Remote control “OFF”
Turn boat to Starboard
Auto-OFF
appr. 4 min.
Hold for
2 seconds
RC-20E
To Next Page
Loading...
Need help?
General
