EasyManuals Logo

Side-Power SR 80/185 T User Manual

Side-Power SR 80/185 T
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
SR80/185T - SR100/185T 1.0.0 - 2009
Vedlikehold
N
Maintenance
GB
» Etterstram boltene som holder girhuset sammen med braketten ved
første på-land servicen med oppgitt moment (s. 9).
» Hold propellen og girhuset fritt for algevekst ved å påføre bunnstoff før
hver sesong.
PS ! Sinkanoder, tetninger og propellaksel skal ikke påføres
bunnstoff, pass på så det ikke kommer bunnstoff i gjenge-
sporene til propellmutteren.
» Skift sinkanode før hver sesong, eller når ca. halvparten av sink-
DQRGHQKDUWUHWERUW%UXN/RFNWLWHHOOHUOLJQHQGHSnVNUXHQWLO
sinkanoden for at den ikke skal falle av. Ta i betraktning at under noen
vannforhold er det nødvendig å montere en ekstra sink-anode for å
YUHVLNNHUSnDWGHVNDOYDUHLKHOHSHULRGHQPHOORPYHGOLNHKROG7D
NRQWDNWPHGGLQIRUKDQGOHUIRULQIRUPDVMRQRPKYRUGDQnJM¡UHGHWWH
» Som en del av det periodiske vedlikeholdet av din båt, og før hver
VHVRQJPnI¡OJHQGHWLQJVMHNNHV
Propellen sitter godt festet.
Boltene som holder elektromotoren til braketten sitter.
At universalleddet i retract-mekansimen er smurt
 6NRWWHWGHUEDXJSURSHOOHQHUPRQWHUWVNDOYUHUHQWRJW¡UW+YLVGHW
HUYDQQLVNRWWHWPnOHNNDVMHQ¿QQHVRJWHWWHV
Alle elektriske tilkoblingspunkter er rene, og godt festet.
Pass på at batteriene er i god stand slik at de kan gi høy spenning til
trusteren. Redusert spenning vil gi redusert effekt på trusteren.
» Retighten the bolts holding the gearhouse to the motor bracket
GXULQJWKH¿UVWRQODQGVHUYLFHZLWKWKHVSHFL¿HGEROWWLJKWHQLQJ
force (see page 9).
» Keep the propeller and gearhouse clean from growth by painting
with antifouling before every season.
PS! The zinc anode, sealing and propeller shafts must absolutely
QRWEHSDLQWHG%HFDUHIXOWKDW\RXGRQ¶W¿OOSDLQWLQWKH³WUDFNV´
in the gearhouse that the propeller hub moves in.
» Change the zinc anode before every season, or when about half
the anode is gone. Always use a sealant on the screw holding the
zincanode to ensure that it does not fall off. Please observe that in
some waterconditions it can be necessary to install an extra
zincanode to ensure that it lasts for the whole period between
regular service lifts of the boat. Consult your dealer for information
on how to do this.
» As a part of the seasonal service of your boat, and before every
season, always check that:
The propeller is securely fastened
The bolts holding the electric motor to the motor bracket are
fastened correctly.
 7KHXQLYHUVDOMRLQWLQWKHUHWUDFWPHFKDQLVPLVOXEULFDWHG
The area where the thruster is installed is clean and dry. If there
DUHVLJQVRIZDWHU\RXPXVWWU\WR¿QGWKHVRXUFHDQGHOLPLQDWHLW
 $OOHOHFWULFDOFRQQHFWLRQVDUHFOHDQDQGIDVWHQHG¿UPO\
Make sure that your batteries are in a good condition so that the
thruster gets a good voltage. Old or bad batteries will give a
reduced performance from the thruster.
Check and relubricate
with waterproof grease if
neccessary
Zinc anode,
retract mechanism
Zinc anode,
gearleg

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Side-Power SR 80/185 T and is the answer not in the manual?

Side-Power SR 80/185 T Specifications

General IconGeneral
BrandSide-Power
ModelSR 80/185 T
CategoryOutboard Motor
LanguageEnglish

Related product manuals