NOTE: Be sure to keep epoxy clear of insert/bolt threads or bolt could
become permanently bonded to insert.
NOTE: Epoxy must harden for at least 45 minutes at 25°C/77°F before
proceeding with the remaining steps. Less time is required for
elevated temperatures and more time for cooler temperatures.
NOTE: Epoxy must cure for at least 24 hours at 25°C/77°F before
operating the thruster. Less cure time is expected for elevated
temperatures and more time for cooler temperatures.
STEP 5: FASTEN CLAMP STRAP
Apply anti-seize compound (included with thruster kit) to threads of the hull insert
bolts.
Apply Sikaflex or equivalent sealant under clamp strap to ensure a sealed joint
Use a
3
/
16
” hex socket driver or hex key to torque the hull insert bolts to 10 foot-
pounds, or until firm but not over-tightened.
Adjust the center bolt at the apex of the clamp strap: loosen the jam nut, adjust to
center, retighten jam nut.
To Next Page