MAINTENANCE
Sideshift thrusters are designed for long life, provided proper maintenance
procedures are followed.
WARNING: When working near or on the Sideshift thruster, always turn
thruster battery switch to “off” position.
Motor Unit
The thruster motor unit is sealed and requires no maintenance. Check for and
tighten any loose fasteners periodically.
ANODES
The sacrificial anodes are designed to slowly corrode, thus protecting the motor
housing from corrosion.
Replace the anodes every year. If anodes are not properly maintained, the motor
may corrode and damage could occur.
To remove the anodes, use pliers to turn counter-clockwise.
To install new anodes, hand tighten until firm, then give them an extra half turn.
PAINT
To touch-up or repaint the thruster and mounting hardware, remove any loose paint
and scuff the surface for proper adhesion. Use any good quality acrylic enamel paint,
also available for order through Sideshift.
Battery
Ensure batteries are always fully charged. Unlike other battery technologies such
as NiCad, batteries should be lightly cycled. Avoid discharging beyond 75%
capacity and even less if possible. Allow battery to cool after charging and
before use otherwise battery life will be reduced . To verify charge, measure the
terminal voltage of the battery with no load, and refer to the chart below to
determine the health of your battery:
To Next Page
Loading...