STEP 8: INSTALL COWLING
Remove marking tape.
Slide cowling in from the top of the thruster unit.
Push cowling all the way down.
Using the hole at the top of the cowling as a guide, drill a
3
/
8
” hole through the bow
to accommodate the top bolt.
Fasten side screws.
Apply Sikaflex or equivalent sealant to the hole from the outside.
Pass bolt through top hole. Slide washer and nut in from the inside of the boat.
Apply anti-seize compound (included with thruster kit) to threads of the bolt.
Tighten snugly with a wrench. Note: For installations where top bolt is too
long, use supplied spacers to compensate.
To Next Page