EasyManua.ls Logo

Sideshift SS Series - Operating the Wireless Remote

Default Icon
61 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIDESHIFT INSTALLATION GUIDE V2.7
52
OPERATING THE THRUSTER
WARNING: Ensure main ignition and thruster battery switch are turned off
when conducting maintenance and repair of the thruster.
WARNING: Use extreme caution when swimmers are in the area of the thruster.
Turn off ignition and avoid contact with thruster props when boat is
stationary.
WARNING: For optimal thruster performance and to prevent overheating
operate the Sideshift thruster in short bursts of 3-5 seconds at a
time as a standard practice. Never run for more than 30 seconds at
a time.
WARNING: When operating out-of-water do not run thruster for longer than
5 seconds to prevent overheating.
WARNING: If conducting an in-water installation, use a cordless drill only, as a
corded drill can present an electrocution hazard.
1. Turn power on to the joystick by holding the power button for 1 second. A
beep will sound and the blue joystick light will activate indicating the thruster
is ready for use.
2. To prolong motor life use the thruster in short 3-5 second bursts as required.
Do not run for more than 20-30 seconds at a time.
3. The joystick will automatically power-off after 10 minutes of non-use.
OPERATING THE WIRELESS REMOTE
1. For operation of the wireless remote the joystick must be powered on.
2. Push the top left or right buttons as required to operate the bow thruster.