Attach positive cable (connected to “BATTERY POS” post on motor controller) to the
positive post of the battery. Slip battery protector over terminal.
Repeat steps for “BATTERY NEG” cable.
STEP 5: CONNECT THRUSTER TO MOTOR CONTROLLER
If thruster power cables are too long, cut them to length. Be sure that they are
neatly routed, and comfortably reach the motor controller terminals. Leave some
slack to make installation easier.
Fit battery protectors and then shrink tube over each thruster lead at the cable end.
For all thrusters use terminal lug part# M1 and M2
Connect one cable to “M1” and the other to “M2” on the motor controller solenoid.
NOTE: Motor power cable polarity is not identified. If thrusters operate
in opposite direction from joystick, reverse S1/S2
connections on motor controller.
To Next Page