INSTALLATION INSTRUCTIONS
– WIRELESS JOYSTICK
Sideshift Wireless Joysticks make installation very straight forward. The joystick
itself requires a 12V power source taken from the helm. The wireless receiver is
installed next to the motor controller.
STEP 1: INSTALL JOYSTICK ON CONS OLE
a. Locate a position on the console of the boat suitable for the joystick.
Check under the selected position on the console to ensure a minimum
area of at least 4” diameter and a minimum three inches obstruction-free
below the area of the joystick equipment.
b. Peel the backing and place the supplied template in the chosen location.
c. Using a 3/16” bit, drill a hole at the center of the template, marked by the
cross-hairs.
To Next Page