sidhil Artemis - Cycle Time Adjustment; Auto Lock Configuration; Weight Unit Selection; Weight Display Toggle

20
2) Auto lock: When pressed a menu appears offering 2 different settings:
By selecting ‘disable’ the interface will not automatically lock itself (see section
9.5.3.1).
Use the up/down cursor key followed by the selection key to initiate the chosen
setting.
The lock is only to be disabled in an environment where intentional/
unintentional tampering cannot occur – Sidhil recommend that the lock
is always set to ‘enable’ regardless of the environment.
Warning
Use the up/down cursor key followed by the selection key to initiate the chosen unit
of measure.
2: Auto Lock a: Enable
b: Disable
3) Weight unit: When pressed a menu appears offering 2 different settings:
3: Weight Unit a: kg
b: lbs
4) Weight display: When pressed a menu appears offering 2 different settings:
4: Weight display a: on
b: off
Use the up/down cursor key followed by the selection key to show/hide the weight
indicator on the main screen.
By selecting this function the cycle time of the alternation sequence can be manually
altered, dependent on the patient’s requirements. Note, the default cycle time for
the system when first turned on is 10 minutes.
Use the up/down cursor key followed by the selection key to initiate the chosen
setting.
1) Cycle time: When pressed a menu appears offering 3 different settings:
1: Cycle Time a: 10 mins
b: 15 mins
c: 20 mins