Fig. 5: Step 2: Installation of the USB Driver
Activate the option “Install the software automatically (Recomended)” and click on
“Next”
The USB driver will be installed automatically. If Windows asks you to enter the path of
the USB driver, click on the button “Browse” and follow the following path:
C:\sm_wprog\sm_drv\USBDRIVER
Fig. 6: Step 3: Installation of the USB Driver
▶ Click on “Finish” to finish the installation of the USB driver.
▶ Overwrite the file “siebmeye.ini” in the directory “C:\sm_wprog” with the original file
of the old system (the backup file created before).
▶ Start the installation of the USB driver again, all necessary modifications in the
“siebmeye.ini” file will be done by the software.
▶ To recover the original system, you can overwrite the other directories and files
with the backup files created before.
The device is ready for operation.
W
Software and Driver Installation
0460123A/0480123A/0480123D - 29
6
To Next Page
Loading...
