Criteria Standard Property, characteristic value Unit
Solid matter content, particle sizes >
25 µm
DIN 51813 < 10 mg/kg mg/kg
Suitability of bearings
Speed characteristic nxdm
- Suitable for the built-in motor bearings, seals and
these speeds
-
mm/min
If different special lubricating greases are stated on the lubricant plate, then different criteria apply.
Note
Deviating operating conditions and characteristics
Only those greases named on the lubricant plate may be used.
If the operating conditions and characteristics differ from those mentioned, other greases may
be used only after consultation with the manufacture.
Note
Use of other greases
If greases other than those named on the lubricant plate are used, it cannot be guaranteed
that they are compatible with the complete system.
If you use greases that satisfy only the minimum requirements of DIN 51825 or ISO 6743-9,
then reduce the lubrication intervals by half or adapt them as appropriate. If in doubt, consult
the manufacturer.
Recommended greases for roller bearings
For standard applications, the following high-quality greases are recommended for roller
bearings for vertical and horizontal motor constructions due to their technical properties:
Table 9-4 Roller bearing greases for vertical and horizontal types of construction
Manufacturer Grease type
Shell Gadus S2 V100 3
ExxonMobil Unirex N3
Esso
BP Energrease LS3
Fuchs Renolit H443 HD88
Lubcon Turmoplex 3
Addinol LM 3 EP
FAG Arcanol Multi 3
For motors of horizontal construction you can alternatively use greases with NLGI class 2.
However, this reduces the lubrication interval by 20%.
Maintenance
9.1 Inspection and maintenance
SIMOTICS TN Series N-compact 1LA8
102 Operating Instructions 05/2016
To Next Page
Loading...
