Transport, storage and packing
9229 9992 176 0D 9
2013-07-08
Transporting without pallet • Remove all tensioning belts and bits of fastening wood.
• Remove accessory pack, if applicable.
• Screw suitable eye bolts into the outer pole heads parallel to each other.
• Hang sling gear into the eye bolts.
• Carefully lift vacuum circuit-breaker off the pallet just enough that pieces of
square timber can be placed underneath.
Note
When fastening the eyebolts to the pole heads, ensure that the contact surfaces
are not damaged.
Fig. 6 Removing the tensioning belts Fig. 7 Screwing in eye bolts and lifting the vacuum
circuit-breaker
Note
Place pieces of square timber onto the pallet in such a way that the insulating
operating rods, contact pressure springs, angle levers and dashpots are not
damaged when setting down.
To Next Page
Loading...
