Transport, storage and packing
8 9229 9923 176 0B
2013-09-09
Transporting without pallet • Removing tensioning belts.
• Remove accessory pack, if applicable, and store safely in the packaging for
later attachment.
• Hang sling gear into the crane eyes.
• Carefully lift vacuum circuit-breaker module.
• Transport to installation site or leave suspended from crane for further work
steps.
Reusing the transport unit
Reusing the transport unit To transport the vacuum circuit-breaker module again, the pallet with carton and
most of the components can be reused.
Do not reuse severed tensioning belts or plastic wrap.
Pack the vacuum circuit-breaker module in reverse order:
• If the transport bracket was already removed, re-mount in reverse order (see
“Delivery state with transport bracket” on page 36). The transport bracket serves
to lock the withdrawable part in place in the cartridge insert during transport.
• Attach the vacuum circuit-breaker module safely to the pallet using the appropri-
ate tools.
• Cover with film and seal with adhesive tape.
• Attach accessories pack.
• Attach carton securely to the pallet floor.
• Before returning to the factory, ask the responsible sales representative for a
returned goods number (see also “Service”, on page 51).
• When returning a vacuum circuit-breaker module, always indicate the type and
serial number (see “Rating plate” on page 27).
Fig. 5 Removing the tensioning belts Fig. 6 Lifting the vacuum circuit-breaker module
Note
If necessary, keep accessory pack on hand for the installation.
To Next Page
Loading...
Need help?
General
