09.02 Start-Up
Siemens AG 6SE7087-6AK85-1AA0
4-59
Rectifier/Regenerating Unit Operating Instructions
Index Meaning for CBP2
010
L byte: Mirroring of P918 (CB bus addr.)
H byte: Reserved
011
L byte: "Re-config. by CUD" counter
H byte: "Initialization runs" counter
012
L byte: Error ID DPS manager error
H byte: Reserved
013
L byte: PPO type found
H byte: Reserved
014
L byte: Mirroring of "DWord specifier ref"
015
H byte: Mirroring of "DWord specifier act"
016
L byte: DPV1:DS_Write, pos. ack. counter
H byte: Reserved
017
L byte: DPV1:DS_Write, neg. ack. counter
H byte: Reserved
018
L byte: DPV1:DS_Read, pos. ack. counter
H byte: Reserved
019
L byte: DPV1:DS_Read, neg. ack. counter
H byte: Reserved
020
L byte: DP/T:GET DB99 pos. ack. counter
H byte: DP/T:PUT DB99 pos. ack. counter
021
L byte: DP/T:GET DB100 ps. ack. counter
H byte: DP/T:PUT DB100 ps. ack. counter
022
L byte: DP/T:GET DB101 ps. ack. counter
H byte: DP/T:PUT DB101 ps. ack. counter
023
L byte: DP/T service neg. acknow. counter
H byte: DP/T:Application association pos. acknow. counter
024
Reserved
025
Date of creation: Day, month
026 Date of creation: Year
027 Software version (Vx.yz, display x)
028 Software version (Vx.yz, display yz)
029 Software version: Flash-EPROM checks.
030 Reserved
031 Reserved
032 Reserved
Fault and alarm messages:
For details about fault messages, see Section 7.
Fault F080
An error occurred as board CBP2 was being initialized, e.g. incorrect value of a CB parameter, incorrect
bus address or defective module.
Fault F081
The heartbeat counter (counter on CBP2) which is monitored by SIMOVERT 6SE70 for "signs of life"
from the board has not changed for at least 800 ms.
Fault F082
Failure of PZD telegrams or a fault in the transmission channel.
AoteWell Automation Sales Team
Buy Siemens PLC HMI Drives at AoteWell.com
To Next Page
Loading...