Siemens 7SR105 Rho - Page 69

7SR105 Rho Settings and Instruments
©2018 Siemens Protection Devices Limited Chapter 2 Page 9 of 16
MOTOR METERS
→to view
This is the sub-group that includes all the meters that are
associated with Thermal functionality.
TEST/RESET ► allows access to this sub-group
Motor Status Stopped, running, starting
Last Motor Start Start time, capacity used, and max current
49 Thermal Times To trip, Restart
Motor Run Times HH:MM:SS Current, total, average
Motor Stop Time HH:MM:SS
Emergency Starts 0
Motor Data FLC, Motor Load, Time Running, Rated O/P power, PF, Efficiency,
Service Factor, Hot Stall Time, Cold Stall Time, Locked Rotor
Current, Start Time, Start Method, Vacuum CB.
TEMPERATURE METERS
→to view
This is the sub-group that includes all the meters that are
associated with Temperature
Max Temp Recorded
Input
Temp
Displays the maximum temperature recorded input number
Displays the maximum temperature
Temp1
Displays the temperature
Temp2
Displays the temperature
Temp3
Displays the temperature
Temp4
Displays the temperature
Temp5
Displays the temperature
Temp6
Displays the temperature
MAINTENANCE METERS
→to view
This is the sub-group that includes all the meters that are
associated with Maintenance
TEST/RESET ► allows access to this sub-group
CB Total Trips
Count 0
Target 100
Displays the number of CB trips experienced by the CB
CB Delta Trips
Count 0
Target 100
Displays the number of CB trips experienced by the CB
CB W ear
Phase A 0.00MA^2s
Phase B 0.00MA^2s
Phase C 0.00MA^2s
Displays the current measure of circuit breaker wear.
CB W ear Remaining
Phase A 0.00MA^2s
Phase B 0.00MA^2s
Phase C 0.00MA^2s
CB Trip Time
Time 0.0ms
Displays the circuit breaker trip time to open time. Measured from
CB auxiliary contacts.