Siemens 7SR105 Rho - Page 71

7SR105 Rho Settings and Instruments
©2018 Siemens Protection Devices Limited Chapter 2 Page 11 of 16
BINARY INPUT METERS
→to view
This is the sub-group that includes all the meters that are
associated with the Binary inputs
TEST/RESET ► allows access to this sub-group
BI 1-6 ---- -- Displays the state of DC binary inputs 1 to 6
(The number of binary
inputs may vary depending on model)
BINARY OUTPUT METERS
→to view
This is the sub-group that includes all the meters that are
associated with the Binary Outputs
TEST/RESET ► allows access to this sub-group
BO 1-6 ---- ----
Displays the state of DC binary Outputs 1 to 6. (The number of
binary outputs may vary depending on model)
VIRTUAL METERS
→to view
This is the sub-group that shows the state of the virtual status
inputs in the relay
TEST/RESET ► allows access to this sub-group
V 1-8 ---- ----
Displays the state of Virtual Outputs 1 to 8 (The number of virtual
inputs will vary depending on model)
COMMUNICATION METERS
→to view
This is the sub-group that includes all the meters that are
associated with Communications ports
TEST/RESET ► allows access to this sub-group
COM1
COM2
Displays which com ports are currently active
COM1 TRAFFIC
COM1 Tx 0
COM1 Rx Error 0
COM1 Rx 0
Displays traffic on Com1
COM2 TRAFFIC
COM2 Tx 0
COM2 Rx Error 0
COM2 Rx 0
Displays traffic on Com2
QUICK LOGIC METERS
→to view
This is the sub-group that includes all the meters that are
associated with QuickLogic Equations TEST/RESET ► allows
access to this sub-group
E 1-4 ----
E1 Equation
EQN =0
TMR 0-0 =0
CNT 0-1 =0
E2 Equation
EQN =0
TMR 0-0 =0
CNT 0-1 =0
E3 Equation
EQN =0
TMR 0-0 =0
CNT 0-1 =0