Need help?Do you have a question about the Siemens 7XV5461-0B 00 Series and is the answer not in the manual?
Specifies qualifications and training required for personnel operating the equipment.
Details the fiber-optic interface for remote connection, including connector type and range.
Describes the optical interfaces for protection and remote control channels, including connector type and baud rate.
Explains the isolated changeover contact for the "device ready" signal.
Specifies the voltage input range and connection terminal for auxiliary power.
Details the ST plug fiber-optic connectors for ports 1 and 2, including applicable fiber types and bending radii.
Describes the Echo Mode for testing fiber-optic connections between the repeater and connected devices.
Details the necessary configuration settings in SIPROTEC 4 protection devices for communication.
Provides technical specifications for the 820 nm interface, including connector, wavelength, baud rate, and transmitting power.
Outlines technical specifications for the remote connection interface at Port 3, including connector type and operating mode.
Details the high voltage and impulse voltage tests performed on the device for insulation verification.
Lists EMC immunity tests including high frequency, electrostatic discharge, and HF field irradiation.
Specifies EMC noise emission tests for radio noise voltage, field strength, and voltage fluctuations.
Describes vibration and shock tests performed on the device during its operation.
Details vibration and shock tests relevant to the device's transport conditions.
Covers temperature and humidity limits and test conditions for the device.
Provides dimensions, weight, and degree of protection for the device's housing.
To Next Page
General
