Siemens AEROGYR RWI65.02 - Accessories, Ordering, and Technical Design; Accessory Details and Ordering Information

CM2N3204E / 1.1999 Siemens Building Technologies
2/20 Landis & Staefa Division
• supervise
- the air flow in air ducts
- overloads of circulators, fans and chillers
- overtemperatures of electric air heater batteries
- risk of fire or smoke
- risk of frost
Name Type reference Remarks
FLN communication insert AZI65.1 Not included in delivery
Instructions (de, fr, it) ARG65.43 Included, if ordered
Instructions (en, sv, fi, no) ARG65.44 Included, if ordered
Instructions (nl, es, da) ARG65.45 Included, if ordered
When ordering the controller, please give type reference RWI65.02. To ensure the unit
will be supplied with the correct language version of the instructions (operating card 2,
operating instructions and mounting instructions), please also indicate the type refer-
ence of the instructions required, e.g. ARG65.44 (for English, Swedish, Finnish,
Norwegian).
To order the communication insert, please give type reference AZI65.1.
Controller and, if required, communication insert are packed separately and are also
supplied as separate units.
Name Type reference Data sheet
Temperature detector QAA24, QAA26 1721
QAM22..., QAE21.9..., QAE22… 1771, 1792, 1791
QAD22..., QAC22, QAA64 1801, 1811, 1722
QAF63.2, QAF63.6 1821
CO
2
/VOC sensor QPA62... 1951
Remote setting unit QAA26 1721
FZA21.21, FZA61.11 3470, 3471
Signal source RVL55, RZF61.100 2602, 3472
RZM61.400, PTM1.2Y10 3474, 8161
Actuator SQ...6... 4553, 4574, 4685, 4686
Automatic detector identification (ASD logic), including type of detector (active or pas-
sive). Automatic activation of optimum controller configuration through ACC logic which,
via ASC, identifies the intended use of the control function. This means that the control
will be optimally matched to the plant. P-band and integral action time (TN) are sepa-
rately adjustable, so that P-control (with integral action time TN = 0) or PI control can be
selected.
The controller is supplied as a PI controller. The setpoints of heating and cooling can be
adjusted separately. Overlapping of heating / cooling sequences is not possible.
For the control of mixed air dampers or HR equipment, both the operating action and
the operating mode can be selected.
The actual values of the various outputs are permanently displayed.
Accessories
Ordering
Equipment
combinations
Technical design
Control