Siemens AG SPR2-320.814.03.02.02 ARCADIS Orbic
06.05 CS SD 24
Prerequisites 5
Page 5 of 16
Medical Solutions
A Siemens engineer is responsible for attaching the grid holder to the image intensifier,
testing and loading the SW, calibration without the marker ring on the I.I., as well as con-
figuration.
An additional calibration must be performed with the navigation system installed (marker
ring on the I. I.). Therefore, an engineer from the navigation company must be participate
in the calibration.
Two engineers use a test body to check the interaction of the two systems and the overall
accuracy.
The test body always remains with the customer.
The overlap time of the two engineers is approx. 2 hours.
The navigation system is handed over by the navigation company.
General requirement 0
Support for startup from the navigation company should be provided on site.
Required documents 0
System requirement 0
ARCADIS system software VB11 or higher.
Required parts 0
TCP/IP type cross-over cable for a direct connection to the navigation system (not
included in the shipment).
TCP/IP cable for a connection to the navigation system via the clinical network (not
included in the shipment).
3D navigation kit: 80 81 452
Required license key 0
System configuration SPR2-320.843.02.01.02
Image quality test SPR2-320.820.02.01.02
3D navigation license key Part No.: 80 81 528
3D license key Part No.: 80 81 502
To Next Page
Loading...
Need help?
General
