Instruction manual AQ101, AQ101D, AQ110P, AQ01 24 (48)
3.2 AQ01 ARC FLASH SENSOR
Figure 3-3: AQ01 sensor configuration
Sensor connectors are located at both ends of the sensor for series
connecting maximum three sensors in one line.
After connecting the sensor to relay, the ERROR LED turns on, and
the appropriate sensor channel LED starts to blink.
Press and hold the SET button on the front panel for 3 seconds to
run system auto-configuration setting.
See configuration related technical instructions in chapter 3.1.3.
To Next Page
Loading...
