Siemens Arcteq AQ101 - 1.2 WIRING; 1.2.1 AQ110 P ARC FLASH PROTECTION RELAY

Instruction manual AQ101, AQ101D, AQ110P, AQ01 9 (48)
1.2 WIRING
1.2.1 AQ110P ARC FLASH PROTECTION RELAY
X1
Function
X2
Function
Binary input 2 – Negative
Binary input 1 – Negative
Binary input 2 – Positive
Binary input 1 – Positive
Binary output 1 - +24V output
Trip contact T1
Binary output 1 – GND output
Trip contact T1
Sensor Channel 1 - Supply
Trip contact T2
Sensor Channel 1 – Signal
Trip contact T2
Sensor Channel 1 – Grounding
Trip contact T3 *
Sensor Channel 2 - Supply
Trip contact T3 *
Sensor Channel 2 – Signal
Trip contact T4
Sensor Channel 2 – Grounding
Trip contact T4
Sensor Channel 3 - Supply
Self-supervision contact – normal
state
Sensor Channel 3 – Signal
Self-supervision contact – failure
state
Sensor Channel 3 and 4 – Grounding
Self-supervision contact – common
Sensor Channel 4 - Supply
Power supply – positive
Sensor Channel 4 – Signal
Power supply - negative
X3
S5
Function
Function
Sensor 5 – Receiver **
Current measurement input – L1
Sensor 5 – Transmitter **
Current measurement input – L1
Current measurement input – L2
Current measurement input – L2
Current measurement input – L3
Current measurement input – L3
Current measurement input – Io
Current measurement input – Io
High speed output 1 – Voltage in
High speed output 1 – Voltage out
High speed output 2 – Voltage in
High speed output 2 – Voltage out
Figure 1-4: HSO connection example
*) Trip contact T3 may be normally open or normally closed type. Refer to the ordering codes.
**) Sensor 5 is optional for fiber sensor or quenching device control. Refer to the ordering codes.