To Next PageTo Next Page
Need help?Do you have a question about the Siemens BH17 7ER and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | BH17 7ER |
| Category | Smoke Alarm |
| Language | English |
Outlines essential health and safety guidelines for personnel and road users.
Details safety requirements for skilled personnel working with the equipment.
Emphasizes the importance of warning road users about potential dangers during installation.
Explains the handbook's role within a series of general traffic handbooks.
Defines the handbook's coverage of loop detector installation and commissioning.
Lists other relevant Siemens and manufacturer handbooks for related equipment.
Covers the process of planning and preparing cables for connection at intersections.
Explains the methods and materials for joining feeder cables and loop tails.
Outlines the procedure for preparing cables for jointing using crimp tools.
Specifies cable types, slot widths, and depths for loop installation.
Discusses considerations for placing loops and tails, including metal objects and buried cables.
Guidance on using existing diamond loops with replacement controllers.
Instructions for re-cutting diamond loops or using chevron configuration.
Specifies re-cutting procedures for SDE/SA loops based on spacing.
Advises on selecting loop pitch on Soundmark Test Sets for different equipment.
Step-by-step guide for marking diamond loop positions before cutting slots.
Notes on marking chevron loops, referencing figures and local authority instructions.
Illustrates and describes UD loop configurations for various systems.
Shows configurations for turning and SDE/SA loops and notes on spacing.
Recommends diamond loop sizes and configurations for MOVA systems.
Illustrates queue loops and special purpose loops with variable dimensions.
Describes how to lay loop cables, including winding, crossing, and taping tails.
Details backfilling techniques for slots containing loop cable using sand, bitumen, or epoxy.
Lists suppliers for epoxy materials and joint sealers.
Details sensitivity settings for VA, SDE/SA, SCOOT, and MOVA loops.
Defines presence time and its normal setting for road traffic use.
Covers the process of planning and preparing cables for connection at intersections.
Explains the methods and materials for joining feeder cables and loop tails.
Details the procedure for jointing feeder cables using BICC MPJ series joints.
Describes how to connect feeder cables to loop tails using BICC MPJ series joints.
Provides instructions for preparing and using BICC Bi-Cast Acrylic Resin for joints.
Explains the use of heatshrink joints for connecting feeder cables to loop tails.
Outlines the procedure for preparing cables for jointing using crimp tools.
Introduces the appendix's purpose in assisting with planning near LRT systems.
Lists documents consulted during the preparation of this appendix.
Explains the potential electrical hazards associated with LRT systems.
Recommends minimum separation distances between street furniture and LRT infrastructure.
Advises on cable insulation and separation to withstand touch voltage from LRT.
Warns about potential contact hazards when using tools and test equipment near LRT.
Recommends isolating the interface between LRT and traffic control equipment for safety.
Details front panel rotary switch settings for Microsense detectors.
Explains binary switch settings, PCB links, and mode for Peek/Sarasota detectors.
