Preface
CM 1243-5
4 Operating Instructions, 04/2011, C79000-G8976-C246-01
The necessary configuration steps are described in the form of an overview.
You will also find instructions for operation and maintenance and information on the
diagnostics options of the device.
Required experience
To install, commission and operate the CM, you require experience in the following areas:
● Automation engineering
● Setting up the SIMATIC S7-1200
● SIMATIC STEP 7
● Data transfer with PROFIBUS
Further information
You will find an overview of further reading and references in the Appendix of this manual.
You will also find information about training, Service & Support and who to contact in the
Appendix of this manual.
License conditions
NOTICE
Open source software
Read the license conditions for open source software carefully before using the product.
The acceptance of the disclaimers of liability and warranty it contains is a clear precondition
of the use of open source software.
You will find the license conditions on the data medium with the product documentation.
To Next Page
Loading...
