K44 Duo Installation & User manual 11
ENG
Choose password
The first thing to do before you can start program-
ming is to choose a password.
Press and hold the SW1 button on the code
lock’s circuit board. Both LEDs are lit.
Enter a 6-digit password.
Make a note of the new password in the chart at
the back of the manual.
Change password
Press B and enter the current password.
Enter A27.
Enter the new password. A warning tone is
heard.
Enter the new password once again.
Press B to leave programming mode.
Make a note of the new password in the chart at
the back of the manual.
Programming commands
Always press B and the password before any com-
mands are used.
Leaving the programming mode can be done by
pressing B.
1�
2�
3�
1�
2�
3�
4�
5�
6�
To Next Page
Loading...
