20 K44 Duo Installation & User manual
ENG
Delay on/off
When this function is activated, the following hap-
pens: If a code is programmed to open two doors,
lock relay 2 is not activated until door 1 has been
opened and closed.
If door 2 is opened with the exit button, door 2 has to
be opened and closed before door 1 can be opened.
Note that door contacts must be connected and that
Door control must be activated for this to work.
This is how to activate Delay:
Enter A80.
Enter 1.
To deactivate Delay, press 0 in step 2 instead.
Erase the memory
This is how to erase all programmed information
(including the password):
Press B and enter the current password.
Press SW1 on K44 Duo’s circuit board.
Enter 112186.
Enter 112186 once again. The memory is now
erased and K44 Duo goes back to the factory
settings.
1�
2�
1�
2�
3�
4�
To Next Page
Loading...
