Siemens CP 1242-7 GPRS V2 User Manual

Installation, connecting up, commissioning
3.2 Installing the CP and commissioning
CP 1242-7 GPRS V2
32 Operating Instructions, 10/2016, C79000-G8976-C311-02
Configuration
One requirement for the commissioning of the CP is the completeness of the STEP 7 project
data (see below). You should also read the section "Configuration and operation (Page 37)".
Inserting the SIM card
Note
Inserting and removing the SIM card
Do not inse
rt or remove the SIM card while the CP is operating.
Prior to installation, insert the SIM card in the CP.
Step
Execution
Notes and explanations
1
Turn off the power supply to the station.
2
Release the slide for the SIM card on the
bottom of the CP behind the lower cover by
gently pressing the release pin.
3
Remove the slide from the housing.
4
Insert the SIM card in the slide as illustrated.
5
Push the slide back into the housing, where
it locks gently in place.
6
Turn on the power supply to the station.

Siemens CP 1242-7 GPRS V2 Specifications

General

Brand	Siemens
Model	CP 1242-7 GPRS V2
Category	Controller
Language	English