Configuration and operation
4.9 STEP 7 configuration
CP 1242-7 GPRS V2
56 Operating Instructions, 10/2016, C79000-G8976-C311-02
Partner for inter-station communication
Inter-station communication
In this table, you specify the communications partners of the CP for inter-station
communication. The communications partner is a CP in the partner S7 station.
Connections for inter-station communication run via the telecontrol server.
Note the special features when configuring the data points for inter-station communication in
the section Partner stations (Page 82).
The partner number is assigned by the system. It is required during data point configuration
to assign data points to their communications partners.
You specify the partner CP for inter-station communication with the parameters "Project",
"Station" and "Slot".
Here, enter the project number of the CP in the partner station.
You will find the parameter in the parameter group "Security > CP identification" on the
partner CP.
Here, enter the station number of the CP in the partner station.
You will find the parameter in the parameter group "Security > CP identification" on the
partner CP.
Here, enter the slot number of the CP in the partner station.
You will find the parameter in the parameter group "General" on the partner CP.
Activate the option for enabling inter-station communication.
When enabled, the frames are stored in the send buffer (frame memory) of the CP if the
connection is disturbed. Note that the capacity of the send buffer is shared by all
communications partners.
To Next Page
Loading...
