Siemens CP 1242-7 GPRS V2 User Manual

Preface
CP 1242-7 GPRS V2
4 Operating Instructions, 10/2016, C79000-G8976-C311-02
Product names
●
CP
In this document, the term "CP" is also used instead of the full product name
"CP 1242-7 GPRS V2".
●
TCSB
TeleControl Server Basic V3, OPC server for telecontrol communication
Purpose of the manual
This manual describes the properties of this module and supports you when installing and
commissioning the device.
The necessary configuration steps are described in the form of an overview.
You will also find instructions for operation and information about the diagnostics options of
the device.
New in this issue
● New functions in the firmware version named above:
– Changed behavior during time-of-day synchronization, see section Time-of-day
synchronization (Page 46).
– Changed selection of supported data types, see section Datapoint types (Page 67).
– Support of S7 routing
● Editorial revision
Replaced manual issue
Release 01/2015
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15921/man)
Required experience
To install, commission and operate the CP, you require experience in the following areas:
● Automation engineering
● Setting up the SIMATIC S7-1200
● SIMATIC STEP 7 Basic / Professional
● Data transfer via mobile wireless networks and Internet

Siemens CP 1242-7 GPRS V2 Specifications

General

Brand	Siemens
Model	CP 1242-7 GPRS V2
Category	Controller
Language	English