Siemens CP 1243-7 LTE - Installing the CP and commissioning

Installation, connecting up, commissioning
3.2 Installing the CP and commissioning
CP 1243-7 LTE
36 Operating Instructions, 04/2017, C79000-G8976-C381-03
Configuration
One requirement for the commissioning of the CP is the completeness of the STEP 7 project
data (see below). You should also read the section "Configuration (Page 41)".
Inserting the SIM card
Note
Inserting and removing the SIM card
Do not insert or remove the SIM card while the CP is operating.
Prior to installation, insert the SIM card in the CP.
Step
Execution
Notes and explanations
1
Turn off the power supply to the station.
2
Release the slide for the SIM card on the
bottom of the CP behind the lower cover by
gently pressing the release pin.
3
Remove the slide from the housing.
4
Insert the SIM card in the slide as illustrated.
5
Push the slide back into the housing, where
it locks gently in place.
6
Turn on the power supply to the station.