Siemens CP 342-5 - A Certifications and approvals; Approvals issued; Approvals of the CP 342-5; CP 342-5 FO

CP 342-5 / CP 342-5 FO
Manual, 07/2017, C79000-G8976-C146-10
43
Certifications and approvals
A
Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which o
f the following approvals have been granted for your product by the
markings on the type plate.
Approvals for shipbuilding are not printed on the device type plate.
Approvals of the CP 342-5 / CP 342-5 FO
WARNING
Information on standards and approvals
Before you put the device into operation, read the information on standards and approvals
in Part A of this manual /1/ (Page 47).
The CP has the following approvals or conforms to the following directives:
● IEC 61131-2
● CE mark
● EMC directive for an industrial environment
– Emission: EN 61000-6-4 : 2007
– Immunity: EN 61000-6-2 : 2005
● Explosion protection directive (KEMA)
● EC machinery directive
● UL 508
● CSA C22.2 No. 142
● UL 1604 / UL 2279 Pt. 15 cULus HazLoc Class I, Div. 2 / Class I, Zone 2, T4 or
ANSI/ISA 12.12.01 cULus HazLoc Class I, Div. 2 / Class I, Zone 2, T4
● FM 3611
Class I, Division 2, Group A, B, C, D T4 or
Class I, Zone 2, Group IIC, T4