Siemens CPU 314C-2 PtP Hardware And Installation Guide


S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
A5E00105492-03
3
GSD file (device master file) 13-7
+
Highest MPI address 5-33
Highest PROFIBUS DP address 5-33
,
Inscription labels 6-2
installation
horizontal 5-3
vertical 5-3
Installation
arranging modules 5-7
grounded reference potential 5-18
in cabinets 5-11
ungrounded reference potential 5-19
Installing
the module 10-7
the modules 6-8
Installing EMC plants 12-3
Instance data block 13-7
Interface modules
connecting cables 5-8
interfaces
MPI interface 5-35
Which devices can I connect to which
interface? 5-37
Interfaces
PROFIBUS DP interface 5-36
PtP interface 5-36
Intermediate memory 9-28
Internet 1-6
interrupt
Process 13-11
Update interrupt 13-8
Interrupt 13-7
Delay 13-7
diagnostic 13-4
on the DP master 11-21
status interrupt 13-7
time-of-day 13-8
vendor-specific interrupt 13-8
watchdog- 13-8
Interrupt, time-of-day 13-8
Interrupt, watchdog 13-8
/
labeling strips
assignment to modules 7-13
inserting 7-13
LED 11-10
Lightning protection equipotential bonding
12-20
Lightning protection zone concept 12-18
Load
from PS 307 5-29
Load circuits
ground 5-24
Load current
determining 5-28
load memory 13-8
Load voltage
connecting the reference potential of the
load voltage 5-25
Local data 13-8
Local equipotential bonding 12-22
0
Main memory 13-8
Mains voltage selector switch 7-5
Material
required 6-3
memory
System 13-14
User 13-15
Memory
back-up 13-1
Load 13-8
main 13-8
Memory bits 13-9
Memory Card
backing up operating system 10-2
Memory reset
with mode selector 9-13
Micro Memory Card
backing up operating system 10-2
inserting 9-10
replacing 9-10
Mode selector
memory reset with 9-13
Modifying
of variables 11-1
module
Installing 10-7
removing 10-5
replacing 10-4
Module
arrangement 5-7, 5-9
dimensions 5-4
installation 6-8
labeling 7-13
start addresses 8-1
Module diagnostics 11-25
Module Parameters 13-9
module replacement
controlling 10-4
Modules
isolated 5-20
non-isolated 5-20
Monitor and control variable
Setting the trigger points 9-19
monitor and control variables
controlling variables 9-19

Siemens CPU 314C-2 PtP Specifications

General

Brand	Siemens
Model	CPU 314C-2 PtP
Category	Processor
Language	English