Siemens DOW1171 - Replacing the Glass Plate on the Manual Call Point SMF121

Maintenance / troubleshooting
Replacing the glass plate on the manual call point SMF121
7
72 | 82
Building Technologies
009865_m_en_
--
Fire Safety
2015-11-06
7.9 Replacing the glass plate on the manual call point
SMF121
w A new glass plate is ready.
w The manual call point SMF121 is installed on the radio base SMF6120.
1. Open the door using a suitable key. NOTICE! Keep the key in a safe place.
2. Remove the old glass pane.
3. Push the retainer (1) to the right.
4. Place the glass pane under the guide (2) and under the retainer (1). The glass
pane is square-shaped and can be inserted in any direction.
5. Release the retainer (1).
6. Close the door.
Figure 7: Replacing the glass plate on the SMF121
1 Retainer 2 Guide
See also
2 Glass insert [➙ 34]