Siemens EQ500 integral TQ51 Series - 8.8 Special Drinks and Hot Water

operation en
53
8.7 Dispensing coffee drinks
with milk froth
Requirements
¡ The milk container has been con-
nected.
¡ The milk container has been filled
with sufficient milk.
1. Place your pre-warmed cup under
the outlet system.
2. Press the symbol for a coffee drink
with milk.
a The display will show the drink and
your current settings.
→"Drink settings", Page54
3. Change the settings where neces-
sary:
‒ To adjust the per-cup quantity,
press .
→"Adjusting the amount",
Page54
‒ To adjust the coffee strength,
press .
→"Adjusting the coffee
strength", Page54
‒ Use the ground coffee compart-
ment.
→"Dispensing a coffee drink
made from ground coffee",
Page51
4. Press and wait until the pro-
cess is complete.
After preparing the drink, the milk
system will automatically clean it-
self with a short jet of steam.
Tip:If you want to stop the dispens-
ing process early, press . If you
want to stop the dispensing process
altogether, press ⁠.
8.8 Dispensing special drinks
Your appliance has other drinks be-
sides the ones that you can obtain
via the quick-selection buttons.
▶ Press several times.
→"Drinks overview", Page47
8.9 Dispensing milk froth
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶ Never touch the milk system when
it is hot.
▶ Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk container has been con-
nected.
¡ The milk container has been filled
with sufficient milk.
1. Place your pre-warmed cup under
the outlet system.
2. Press repeatedly until the dis-
play shows "Milk froth".
3. Change the setting if necessary:
‒ To adjust the per-cup quantity,
press .
→"Adjusting the amount",
Page54
4. Press ⁠.
a The milk froth will run out of the
outlet system.
5. Press to stop the dispensing
process.