Siemens EQ500 integral TQ51 Series - Page 62

en Cleaning and servicing
62
¡ If you are using the service pro-
grammes "Descale" or
"calc'nClean", first clean the brew-
ing unit and prepare the descaling
solution.
1. Press ⁠.
2. Use and to select "Cleaning
and care" and press ⁠.
3. Use and to select the re-
quired programme and press ,
e.g. "Descale".
a The display will guide you through
the programme.
Preparing descaling solution
1. Fill a container with 0.5l lukewarm
water.
2. Add a descaling tablet to the water
and stir until it is fully dissolved.
Resetting service programmes
Perform the following steps if a ser-
vice programme is interrupted, e.g.
due to a power failure.
1. Rinse out the water tank.
2. Fill the water tank with fresh, non-
carbonated water up to the "max"
marking.
3. Press ⁠.
a The appliance will rinse itself for
approx.2minutes.
4. Empty and clean the drip tray.
5. Insert the drip tray and close the
door.
6. Restart the service programme.