Do you have a question about the Siemens FDCIO222 and is the answer not in the manual?
Product Type | I/O Module |
---|---|
Type | FDCIO222 |
Number of Inputs | 16 |
Number of Outputs | 16 |
Inputs | Digital |
Outputs | Digital |
Input Voltage | 24 V DC |
Output Voltage | 24 V DC |
Operating Voltage | 24 V DC |
Communication Interface | PROFIBUS DP |
Mounting Type | DIN Rail |
Operating Temperature | -20 to +60 °C |
Humidity Range | 5 to 95% non-condensing |
Voltage Range | 20.4 to 28.8 V DC |
Compatibility | Siemens SIMATIC S7 |
Defines the input/output module's purpose for control and monitoring of potential-free contacts.
Outlines steps before installation, defining place of use and type of installation.
Details steps for installing the module within the FDCH221 housing, including cable entries.
Instructions for mounting the input/output module onto a top hat rail using mounting feet.
Guidance for securing the input/output module onto a flat surface using screws.
Steps for connecting cables and resistors to the module's terminals, noting polarity and cable types.
Order details for the FDCIO222 input/output module.
Order details for the FDCIO224 input/output module.
Order details for the FDCH221 housing.
Order details for the FDCM291 mounting foot accessory.
Order details for a metal cable gland with M20 x 1.5 thread.
Order details for a counter nut designed for M20 x 1.5 fittings.
Order details for a 2.4 x 137 mm polyamide cable tie.
Order details for a 3k01 Ohm, 1%, 0.25 W resistor.
Order details for a 1k15 Ohm, 1%, 0.25 W resistor.
Order details for a 2k7 Ohm, 1%, 0.35 W resistor for FDCIO224.
Order details for a 560 Ohm, 1%, 0.25 W resistor for FDCIO224.
Order details for a connection terminal supporting 1 to 2.5 mm² wires.