Need help?Do you have a question about the Siemens FDCIO223 and is the answer not in the manual?
General| Product Type | I/O Module |
|---|---|
| Product type designation | FDCIO223 |
| Number of Inputs | 8 |
| Number of Outputs | 8 |
| Input Voltage | 24 VDC |
| Output Voltage | 24 VDC |
| Operating Voltage | 24 VDC |
| Communication | FDnet/C-NET |
| Mounting Type | DIN Rail |
| Housing Material | Plastic |
| Protection Class | IP30 |
| Relative Humidity | 5 % to 95 % (non-condensing) |
| Weight | Approx. 200 g |
| Output Current | 0.5 A per channel |
| Operating Temperature | -20°C to +60°C |
Describes the document's objective and scope for safe product use.
Identifies intended users and their required qualifications.
Details general safety notices, symbols, and hazard warnings.
Outlines rules for electrical installations and operational safety.
Lists standards and directives the product adheres to.
Provides information on firmware version limitations and specific warnings.
Introduces the module's operation, features, and system integration.
Describes the module's physical components, protection, and overview diagram.
Explains module functions, primary/secondary sides, and configurations.
Shows possible configurations for inputs/outputs independently.
Explains module self-monitoring and diagnosis levels, including error messages.
Describes how the system operates when the control panel fails.
Lists available accessories for the module.
Lists compatible fire detection systems.
Guides on choosing mounting location and configuring lines.
Details parameters for detector line configuration.
Details parameters for control line configuration.
Details parameters for contact input configuration.
Discusses factors affecting device performance in industrial settings.
Instructs on completing the configuration sheet.
Provides steps for installing the module inside the FDCH221 housing.
Details steps for installing the module directly onto a surface or DIN rail.
Explains how to connect the module, including shielding and grounding.
Explains the process of calibrating the control line.
Describes how to check the module's status using the MC link.
Recommends periodic checks for device operability.
Provides detailed technical specifications for the module.
Shows the physical dimensions of the module and housing.
Discusses material composition and recycling aspects.
Lists compatible devices for Siemens/Cerberus and SynoLINE300 detector lines.
Provides templates for planning application and detector/control lines.
Provides an alphabetical index for document content.
To Next Page
