Siemens FDCIO223

Annex
65
Building Technologies
009122_e1_en_--
Fire Safety
2015-10-06
9.2 Configuration sheet
Planning the type of application
Mounting site ________________
Mode of mounting □ Without housing
□ With housing FDCH221
Configuration of input/output 'I/O 1' □ Siemens/Cerberus detector line, SynoLINE600
□ SynoLINE300 detector line
□ Contact input
□ Control line without confirmation
□ Inverted control
□ Reverse-polarity monitoring of control
Configuration of input/output 'I/O 2' □ Siemens/Cerberus detector line, SynoLINE600
□ SynoLINE300 detector line
□ Contact input
□ Control line without confirmation
□ Inverted control
□ Reverse-polarity monitoring of control
Ground fault monitoring for both inputs/outputs (jointly) □ Yes
□ No
Planning the detector line
Parameters
Input/output 'I/O 1'
Input/output 'I/O 2'
Detector line type □ SynoLine300
□ Siemens/Cerberus, SynoLINE600
□ Siemens/Cerberus ex line
□ SynoLine300
□ Siemens/Cerberus, SynoLINE600
□ Siemens/Cerberus ex line
Alarm verification □ No
□ Yes => alarm verification time = _____s
□ No
□ Yes => alarm verification time = _____s
End-of-line
□ EOL22(Ex);obligatory in
Ex area, 20 V -voltage reference diode
□ EOL22(Ex);obligatory in
Ex area, 20 V -voltage reference diode