Siemens FM 458-1 DP - Page 67

SIMOLINK drive coupling
5-10 Function Blocks - FM 458-1 DP
Edition 12.2004
I
TAD
SLB hardware address (name of the SLB module), which can be
configured in HWConfig
FSL
Address of the first slave from which the actual value YA0 should
be received, value range 1 . . . 200
(initialization connection)
(default: 1)
NSL
No. of slaves, from which actual values are to be received,
value range 1. . . 8
(initialization connection)
(default: 1)
CSV
Channel number on which the actual value is received,
value range 0 . . . 7
(initialization connection)
(default: 0)
QV
Enable cross-data transfer
This is used, if data is to be sent to a slave in the same cycle which
is physically located in front in the SIMOLINK ring (e.g. from slave 4
to slave 1).
(default: 0)
YA0 to
YA7
Actual value YA from slaves 1 to 8
A maximum of 8 actual values can be received.
(default: 0)
SEQ
Sequence number
Number of the block in the SIMOLINK block sequence
The value supplies info as to whether the block was correctly
initialized.
(default: 0)
YF
Error status of the block
YF=0 no error, YF > 0 refer to coded error output @SL
(default: 0)
QF
Group error bit
QF=0 no error, QF=1 for error (if YF≠0)
(default: 0)
Computation time [µs] FM 458-1 DP 34,7
Can be inserted online No
Can be configured in Interrupt tasks
Cyclic tasks
Executed in Initialization mode
Normal mode
Special features -
I/O
Configuringdata