Siemens Gigaset 3000 Classic - Base station and dialling modes

19
Gigaset 3000 Classic, IM1-En, A31008-G3000-B001-50-
3000Cla.fm
02.03.00
Changing the base station
Prerequisite:
the handset is registered with more than one
base station.
You can choose one of the following settings:
• Set the handset to
automatically select
(factory setting)
the best base (factory setting).
• Set the handset to
priority base station
– the handset
searches for other base stations if this is not found within
30 seconds.
• Set the handset to
a fixed base station
.
z { Press the set key followed by the INT key.
e.g. ¸¸ For example, set base 1 as the priority base.
For
automatic selection:
enter
¨
.
For
priority base:
enter the base number
twice
.
For
fixed base:
enter the base number
once
.
b Save the setting and terminate the function.
Switching to tone dialling
If you are operating the base station in a telephone system
that uses pulse dialling (DP), you can switch to tone dialling
(DTMF), e.g. for telephone banking, to check an external
answering machine, etc.
Prerequisite:
a connection is active.
z Press the set key.
~ Activate tone dialling – tone dialling is active
until the call is cleared down.
3000Cla-IM1-50-en.bk Seite 19 Donnerstag, 2. März 2000 12:51 12