42
Base station settings
Gigaset A200 / englisch / A31008-A200-B101-1-7619 / settings_bs_hs.fm / 16.01.2003
Base station settings
All base station settings are made via a registered Gigaset A 2 handset.
Changing the system-PIN
To protect the system settings from unauthorised access you should change the system-
PIN (factory setting: 0000) to a PIN that only you know.
Return base station to factory (default) settings
A reset does not alter the system PIN; handsets remain registered.
Factory settings of base station
[_______________]MENU
Press display key to open menu.
[__________] [______________________________________________] [__________]
BASE SET OK
Select and confirm.
[__________] [______________________________________________] [__________]
SYSTEM PIN OK
Select and confirm.
[_____ _]
OK
Enter the currently valid system PIN (4 digits) and
confirm. For security reasons the entry is shown as
four stars (
****
).
[_____ _]
OK
Enter new PIN (4 digits) and confirm.
[_____ _]
OK
Repeat new system PIN and confirm.
Long press (return to idle status).
[_______________]
MENU
Press display key to open menu.
[__________] [______________________________________________] [__________]
BASE SET OK
Select and confirm.
[__________] [______________________________________________] [__________]
BASE RESET OK
Select and confirm.
[_____ _]OK
Enter system PIN and confirm.
[______________________________________________] [__________]
RESET ? OK
Confirm safety check.
Default settings Status after
reset
Description
System PIN 0000 unaffected page 42
Barge in deactivated deactivated page 37
Pause after R key 800 ms 800 ms page 44
Pause after line seizure 3 s 3 s page 44
Flash time 120 ms 120 ms page 43
Dialling procedure MFV MFV page 43
Speed dial
1 Mailbox without
number
Mailbox without
number
page 23
To Next Page
Loading...
